Landoll WFPC38-52 Wing Float Pulverizer - Manual (Page 49)

MAINTENANCE
4-3
Fasteners
Before operating your Brillion machine, check all
hardware for tightness. (See “General Torque
Specifications” on page 4-1.)
After a few hours of use, check entire machine and
tighten any loose nuts or bolts. Daily or periodic checks
should be made thereafter.
When replacing bolts, be sure to use fasteners of equal
grade.
Lubrication
Lubricate bearings with quality grease per recommended
lubrication frequency intervals indicated or if machine is
not used for an extended period. Greaseable
components are the same on each side.
Lubricating Wheel Hub: Grease Wheel Hubs every 50
hours.
Repack Wheel Hub bearings annually before each
season usage.

CAUTION
Figure 4-1: Lubrication 1 of 2
Over lubrication of these bearings can cause
premature bearing failure.
Grease Every 20 Hours
5” x 42” or 5-1/2” x 42”
Hydraulic Cylinder
Grease
Every 20 Hours
5” x 42” or 5-1/2” x 42”
Hydraulic Cylinder