Landoll PPF Floating Ring Pulverizer - Manual (Page 14)

1199rev401 6K107
1. Assemble #4K774 to right side of machine frame member. Attach as far to outside of frame as
possible using straps and machine bolts or U-bolts as furnished. See illustration above.
Assemble the other angle in similar fashion on the left side of machine.
2. Attach lamp assemblies with fasteners shown (amber facing forward; red and amber facing toward
the rear with amber above red).
3. Connect “wishbone” wiring harness ends to connectors on lamp assemblies. (IMPORTANT: wires
are color coded on wishbone harness. Connect end with yellow wire to left side lamp
assembly. Connect end with green wire to right side lamp assembly). Run wishbone
harness wires along rear frame member to center of machine.
4. At center of machine assemble the connector of the straight harness to the wishbone harness.
The 7-pin plug on the straight harness connects to the tractor socket when in use. Allow enough
harness length to reach tractor socket and roll or fold up excess. Attach permanently to pulverizer
frame. All wires must be firmly attached to machine frame members so they don’t droop or become
torn loose by field debris. Use plastic cable ties, provided, and electrical tape to secure all wiring.
WARNING LIGHT ASSEMBLY
REAR
#6J150
LOCKNUT, 1/4”
#1C109 LOCKWASHER
#1C390 HEX NUT, 1/2”
#4K773 R.H. LAMP
ASSEMBLY (SHOWN)
#4K772 L.H. LAMP
ASSEMBLY (NOT SHOWN)
#4K782
MACHINE SCREW
1/4” x 1 1/4”
#1C675 BOLT, 6”
#4K937 BOLT, 8 1/2:”
#3J662 STRAP, 5” TUBE
#4K970 STRAP, 7” TUBE
#4K774
ANGLE
Page 12