Landoll HCDA73-1 Soil Builder Coulter Chisel - Manual (Page 29)

ASSEMBLY
2-19
LED Installation Instructions
NOTE
All models similar. See Figures 2-18 and 2-19. Refer to
Figure 2-17 for bracket and light placement dimensions.
1. Attach both Light Brackets to the rear frame using the
1/2-13 U-Bolts and Flange Locknuts.
2. Attach Amber LED to the outside of the Light Bracket
using (4) 1/4-20 x 1-1/4” Screws and Locknuts, then
attach the Red LED next to the Amber LED using (4)
1/4-20 x 1-1/4” Screws and Locknuts
3. Attach the Flasher Control Module under the Module
Bracket using (2) 1/4-20 x 1-1/2” Screws and
Locknuts, then attach the Module Bracket to the top
of the rear frame using 2 (two) 3/8-16 U-Bolts and
Locknuts.
4. Attach the SMV Mount to the rear frame using 1/2-13
U-Bolt and Flange Locknut. Then attach the SMV
Sign to the Mount using (2) 5/16-18 x 1” Screws, Flat
Washers, and Locknuts.
5. Layout the Lamp Harness, noting that the connectors
marked with Green Tape is Right Side and Yellow
Tape is Left Side.
6. Plug the Lamp Harness into the Flasher Control
Module, route both cord plugs with Green Tape along
the top right side of the rear frame. Route the plugs
up through the Light Bracket and plug the 3 prong
cord into the Red LED. Plug the 2 prong cord into the
Amber LED.
7. Repeat for the Left Side (Yellow Tape).
8. Plug the 7 Pin Harness into the Light Module, then
route the harness along the Right Hand Brace and
secure with Tie Straps.
9. Bundle and secure excess cord to the Module
Bracket with Tie Straps. Secure cords along frame
and brace using Tie Straps.
NOTE
All wires must be firmly attached to machine frame
members so they do not sag or become torn loose by
field debris.