Landoll HCDA73-1 Soil Builder Coulter Chisel - Manual (Page 32)

3-2 2J757
OPERATION
For best working results, operate tractor at 4 to 6 miles
per hour. Reduce speed when approaching the end of
the field. When turning or backing up be sure to raise the
machine completely out of the ground. This prevents
damage to the shanks and coulter gang assemblies.
Coulter gang assemblies should be adjusted so that
coulters operate just deep enough to penetrate down
to firm soil and cut the residue. In most cases the more
firm the soil, the less pressure is required on the coulter
gangs. Where more pressure on coulters is desired,
change to the lower clevis pin position. See Figure 3-2.
Figure 3-2: Coulter Pressure
Reflectors and SMV Sign
Reflectors and a slow moving vehicle sign (SMV) are
required if the Wing Float Pulverizer is transported on a
public road. Check with local laws/ordinances. See
Figure 3-3.
NOTICE
Figure 3-3: SMV Sign
Clevis Pin
Normal Postion
OpCD SoilBuildSpringPosition
Clevis Pin
Increased
Pressure
Position
When Transporting on Roadways, Obey all
Applicable Laws and Regulations.