Landoll 3130 SERIES WING PACKER - Manual (Page 23)

3-12 PULL TONGUE ADJUSTMENTS (SMALL MODELS ONLY)
This machine is equipped with a pull tongue
that is adjustable up and down a total of 10-1/2",
as shown.
CAUTION
WITH THE WINGS FOLDED AND THE
UNIT IN THE TRANSPORT POSITION,
THE HITCH COULD SPRING UPWARD
WHEN UNHITCHED FROM THE TRAC-
TOR DRAWBAR.
3-12.1 Lower the machine to the working position
with the wings unfolded for stability.
3-12.2 Level the frame and securely block the
front and rear so it cannot tip. Also, block the
machine so it cannot roll forward or back-
ward.
3-12.3 Loosen the 3/4" bolts where the pull
tongue attaches to the center frame.
3-12.4 Remove the 7/8" bolts and shims.
3-12.5 Position the hitch point at the desired
height. The tongue jack can be used to ad-
just the height. The 3/8" thick shims allow a
total adjustment of 10-1/2" adjustment at
1-1/2" increments.
3-12.6 Replace the shims and the 7/8" bolts.
(Tighten to 350 - 400 ft.-lbs.)
3-12.7 Retighten the 3/4" bolts to 250 - 300
ft.-lbs.
3-11
Figure 3-9 Pull Tongue Adjustments (Small Models Only)