Landoll ICON 819 - Manual (Page 10)

Safety Section
Crushing/Cutting Prevention
Support the machine properly before you perform
any repairs or maintenance beneath that machine.
Do not rely on the cylinders to hold the machine up.
If a control is moved or a hydraulic line breaks, the
machine can fall.
Never attempt adjustments while the machine is in
motion.
Stay clear of all rotating and moving parts.
If it is necessary to remove shields or panels for
repairs/maintenance, be certain to replace them
before using the machine.
When you strike a pin or retainer with force, chips
and other debris can fly off the object.
Make sure that no one can be injured by flying
debris before striking any object. To avoid injury to
your eyes, wear protective glasses when striking any
object.
Make certain that the cylinder stops are in place
before making any adjustment/repairs under the
machine.
The stop pins should be in place on the clam
before working around the front of the machine.
Line, Tubes and Hoses
Inspect all lines and hoses for wear and chaffing.
The hoses must be properly routed and have
adequate support and the clamps should be secure.
Tighten all connections to the recommended
torque.
Do not bend high pressure lines. Do not install any
lines that are bent or damaged.
Repair any lines that are loose or damaged.
Check lines, tubes and hoses carefully. Do not use
your bare hands to check for leaks. Use a board or
cardboard to check, as high pressure fluid can enter
soft tissue.
Tighten all fittings and clamps to proper torque
specs.