Landoll ICON 819 - Manual (Page 61)

ICON In Cab Site Gauge
A three color led readout on a
printed face place, informs the
operator of height, in tenths of a
foot above or below ground, on
the cutting bit, and height in
inches of the front gate.
All gauges are set up for a
front and rear tandem machine,
or can be operated with a single
machine.
A mounting plate and velcro
mounting tape is supplied,
allowing the operator to mount
the gauge at his/her preference.
Usual mounting is directly
above the hydraulic controls,
providing info without turning
around to see the machine(s).
6 1/4
7
1
/4
Shown is the potentiometer that is installed
on each machine (at the appropriate pin
locations). Each wiring harness is made for a
tandem setup, and plugs into each lead on the
potentiometer.
Thickness is 1 1/8”