Landoll ICON 819 - Manual (Page 66)

DEALER 24-36 HOUR SERVICE CHECK LIST
___CHECK HYDRAULIC COUPLERS, LINES AND FITTINGS FOR LEAKS,
AND TIGHTEN IF NECESSARY.
___TORQUE WHEEL BOLTS TO SPECS LISTED ON THE TORQUE PAGE
(Located at the back of the manual)
___CHECK AND TORQUE THE 1” AXLE CLAMP BOLTS TO THE PROPER
SPECS, (ALSO LISTED ON THE TORQUE PAGE
___INSPECT AND TIGHTEN THE AXLE JAM NUTS, IF NECESSARY.
THESE NUTS SHOULD BE TIGHTENED FIRMLY, (a wrench for this
purpose is attached to each machine) UNTIL THE BEARINGS ARE
SEATED IN THE RACE TIGHTLY. THIS ADJUSTMENT SHOULD BE
CHECKED BY THE OWNER/OPERATOR THEREAFTER EACH 1000
HRS. THE TIRES/WHEELS NEED NOT BE REMOVED FOR THIS
ADJUSTMENT, ONLY LIFTED OFF THE GROUND HYDRAULIALLY.
___CHECK AND TORQUE ALL ACCESSABLE BOLTS AND NUTS TO
RECOMMENDED SPECS.
___MAKE SURE THAT ALL GREASE ZERKS HAVE BEEN LOCATED AND
GREASED PROPERLY.
___ONLY HIGH-TEMP GREASE IS RECOMMENDED FOR USE IN THE
REAR AXLE OF THE EARTHMOVER.
___CHECK AND TORQUE THE HITCH PIN RETAINER BOLTS,
_THE CYCLE TIMING OF A FULLY LOADED MACHINE SHOULD BE
OBSERVED AND ADJUSTED (IF NEEDED) TO ASSURE THE GATE
AND WALL ARE CYCLING PROPERLY. IF ADJUSTMENT IS
NEEDED, PLEASE REFER TO THE GUIDE ON THE BACK OF THIS
LIST