Binatone 710 - Manual (Page 4)

4
2. Installation
1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:
„ the mains adapter plug will reach an easily accessible 230-V AC
switch mains supply socket - never try to lengthen the mains power cable.
„ the telephone line cable will reach your telephone line socket or
extension socket.
„ it is not close to a sink, bath or shower, or anywhere else where it
might get wet.
„ it is not close to other electrical equipment - fridges, washing
machines, microwave ovens, TVs, fluorescent lights, etc.
2. Plug the coiled handset cord into the Handset. Plug the other end into
the jack on the left side of the Base unit.
Note: The base unit does n't
require a battery.
3. Place the Handset on
the Base unit.
4. Plug the telephone line cord into
the PHONE LINE jack at the back
of the Base unit. Plug the other
end into your telephone line socket 5. Plug the power supply cord
into the POWER jack at the
back of the Base unit. Plug
the other end to a 230V AC,
50Hz mains socket, with the
switch on the socket set to OFF
6.Switch ON the mains power at
the socket. Wait while the
7.Lift the Handset and check
for Dial tone in the earpiece.
The Spirit 710 Base unit must be used
only with the supplied mains adapter. Using
any other adapter may damage the unit.
Always use the telephone
line cord supplied with your
Spirit 710. Other telephone
line cords may not work.
Make sure the plugs click
into place.
or extension socket.
display shows INITIALISATION,
then the announcement
Answering machine on.
Announcement one before
the display changes to the
“
”
standby screen.