Leica Biosystems M205A - Manual (Page 32)

Leica M series Manual 32
The base is delivered with the adapter plate
installed. The selected stage (IsoPro™ cross-
stage or standard stage 10 447 269), and the
focusing drive will have to be mounted later.
Ensure that the instruments are unpacked on a
level, adequately sized, and nonskid underlay.
Stage assembly
The transmitted-light base TL RC™/ RCI™ can
be equipped with three different stages. The
selected stage is mounted on the base before
commissioning. You can switch between the
stages at any time with just a few hand move-
ments.
The following paragraph assumes use of the
base without the stage mounted. Disassembly
is performed in reverse order of the following
steps.
Standard stage
1. Take the glass plate from the rectangular
gap in the standard stage.
2. Position the stage on the transmitted-light
base in such way that the four holes align
over those in the base.
3. Attach the stage to the base using the four
Allen screws provided.
4. Insert the glass plate back into the standard
stage.
TL RC™ / TL RCI™