Lenze 9400 Mounting Instructions - Manual (Page 44)

l
44 EDK94ASH24 DE/EN/FR/ES/IT 4.1
Overview
Standard device 0 Design
Pos. Description HighLine StateLine
MXI1 Module receptacle for extension 1, e.g. communication ю ю
MXI2 Module receptacle for extension 2, e.g. communication þ o
MMI Module receptacle for memory modules ю ю
MSI Module receptacle for safety modules ю ю
X1 System bus (CAN), under the cover þ o
X2 24−V supply and state bus ю ю
X3 Analog inputs and analog outputs 2/2 1/0
X4 Digital outputs 4 1
X5 Digital inputs 8 4
X6 Diagnostics ю ю
X7 Resolver ю ю
X8 Encoder ю ю
2 Lower cap ю ю
3 Nameplate, retractable ю ю
4 Upper cap ю ю
8 EMC clamp 1 1
: Warning sticker − place close to the device in a clearly visible manner! ю ю
The LED display enables fast indication of several operating states.
LED Labelling Colour Description
CAN−RUN green CAN bus o.k.
Inoperable when "StateLine" design is
used
CAN−ERR red CAN bus error
DRIVE READY green Standard device is ready for operation
DRIVE ERROR red Error in the standard device or due to the application
24 V green 24−V supply voltage o.k.
SSP94LED01
USER yellow Message parameterised by the application
Pos. Symbol Description
5
{
Long discharge time: All power terminals carry hazardous voltages for at
least 3 minutes after mains disconnection!
}
High discharge current: Fixed installation and PE connection to EN 61800−5−1
required!
'
Electrostatic sensitive devices: Before working on the device, personnel must
ensure that they are free of electrostatic charge!
Installation backplane 1 Design
Pos. Description HighLine StateLine
X100 Mains / DC−bus voltage þ
X105 Motor / external brake resistor þ
X106 Motor temperature monitoring þ
X107 Control of motor holding brake Optional
X109 DC busbar + Optional
(for DC−bus connection)
X110 DC busbar −
6 EMC wire clamp (for device sizes II + III), replaces 1x 7 1
7 EMC shield clamp 3 or 2
© 2010 Lenze Automation GmbH, Hans−Lenze−Str. 1, D−31855 Aerzen
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Automa-
tion GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software described.
Nevertheless, discrepancies cannot be ruled out. We do not take any responsibility or liability for any damage that may occur. Ne-
cessary corrections will be included in subsequent editions.