Lenze 9400 Mounting Instructions - Manual (Page 62)

Wiring of the standard device 7
l
62 EDK94ASH24 DE/EN/FR/ES/IT 4.1
I
Tip!
Parameter setting and configuration can be carried out using the
L−force »Engineer«. For this purpose the Online Help and the Software Manual
for the standard device will guide you.
System bus CAN on board
Terminal X1 Labelling Description
Pin 2 CAN−LOW
Pin 3 CAN−GND
Pin 7 CAN−HIGH
9400SSP000X1 (Housing) CAN−Shield
)
Note!
The X1 connection is not available in the "StateLine" design.
24 V supply
Terminal X2 Labelling Description
GE GND external supply
24E 24 V external supply via a safely separated power supply
unit (SELV/PELV) (only required for mains−independent supply of the
control electronics)
9400SSP000X2 SB State bus in/out (reference GE)
Terminal data
Conductor cross−section Tightening torque
[mm 2 ] [AWG] [Nm] [lb−in]
Flexible
0.2 ... 2.5 24 ... 12 Spring terminal With wire end
ferrule