Lenze E82ZWBRE - Manual (Page 42)

5 Electrical installation
Wiring in the 8200 motec
EDK82ZWBRE DE/EN/FR 6.0
42
l
H1_E_INST−E82ZxBRx_Kabelquer_EN
0 Connection variant 1:
Z1 Standard I/O function module
The internal voltage source of the function module supplies the digital output.
Control of the brake switch via the digital output of the function module.
1 Connection variant 2:
Z1 Application I/O function module
The internal voltage source of the function module supplies the digital output.
Control of the brake switch via the digital output of the function module.
2 Connection variant 3 (only with 8200 motec, variant V152 or V153):
Z1 Function module
The internal voltage source of the function module supplies the digital output of the
motec.
Control of the brake switch via the digital output of the motec.
Note:
Instead of using the internal voltage source of the function module, you can also supply
the digital output of the motec via an external 24 V DC voltage source.
Terminal data
Conductor cross−section Tightening torque
[mm 2 ] [AWG] [Nm] [lb−in]
Flexible
0.5 ... 1.5 20 ... 16 0.5 ... 0.6 4.5 ... 6.2 With wire end
ferrule