Lenze E94AYCEO - Manual (Page 39)

Electrical installation
EtherNet/IP connection
6
EDK94AYCEO DE/EN/FR/ES/IT 1.0
39
l
H2_EtherNet−Ethernet_KabelSpezifikation
EtherNet/IP connection
You can use a standard Ethernet patch cable for connecting the communication module to
the fieldbus (see "Ethernet cable specifications" (
^ 40)).
Mounting and dismounting of the Ethernet cables has been optimised for the use of
connectors according to the "Automation Initiative of German Domestic Automobile
Manufacturers" (AIDA).
)
Note!
Plug/remove the Ethernet cable plug in a straight manner (at right angles)
into/from the socket to make sure that the RJ45 socket will not be damaged.
Pin assignment
RJ45 socket PIN Signal
1 Tx +
2 Tx −
3 Rx +
4 −
5 −
6 Rx −
7 −
E94AYCXX004C 8 −
I
Tip!
The EtherNet/IP interfaces are equipped with an auto−MDIX function. This
function adapts the polarity of the RJ45 interfaces in a way that,
independently of the polarity of the opposite EtherNet/IP interface and the
cable type used (standard patch cable or crossover cable), a connection is
established.