Lenze GKK - Manual (Page 14)

Mechanical installation
Storage
4

14 BA 12.0032-EN 2.0
4 Mechanical installation

Danger!
Only transport the drive with transport equipment or hoists which are suitable
for this load (see transport weights, chapter 3.4). Ensure a safe fixing. Avoid
shocks!
The motors attached to the gearbox are partially equipped with eyebolts.
These are exclusively determined for motor/gearbox mounting and
dismounting and must not be used for the complete geared motor!
4.1 Storage
If you do not install the gearbox immediately, ensure appropriate conditions of storage.
ƒ Up to one year:
– Without special measures in dry and dustfree rooms and protected from sunlight.
– Store the gearbox with ventilation such that the breather screw is located at the
top.
– Shafts and bright surfaces are delivered with protection against corrosion.
ƒ Over a year:
– Requires consultation with the plant.
4.2 Mounting
4.3 Preparation

Stop!
Thoroughly remove anticorrosion agents from output shafts and flange faces.