Lenze EVS93xx - Manual (Page 23)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Changing and saving parameters
3
l
23 EDKVS93−02 EN 3.0
3.1.4 Changing and saving parameters
)
Note!
Your settings have an effect on the current parameters in the main memory.
You must save your settings in a parameter set so that they are not lost when
the mains are connected.
If you only need one parameter set, save your settings as parameter set 1,
since parameter set 1 is loaded automatically after mains connection.
Step Key
sequence Action
1. Select the menu z y Z Y Use the arrow keys to select the desired menu
2. Change to the code level Z Display of the first code in the menu
3. Select code or subcode y z Display of the current parameter value
4. Change to the parameter level V
5. When SHPRG is displayed, inhibit the
controller S 1) The drive coasts
6. Change parameter
A Z Y Move cursor below the digit to be changed
B y z Change of digit
T y
T z
Quick change of digit
7. Accept the changed parameter
Display of SHPRG or SHPRG p T V Confirm change to accept the parameter
Display "OK"
Display p − The parameter has been accepted immediately
8. Enable the controller, if required U 1) The drive runs again
9. Change to the code level
A V Display of the operating level
B V Display of the code with changed parameter
10. Change further parameters Restart the "loop" with step 1. or 3.
11. Save changed parameters
A z y Z Y Select the code C0003 "PAR SAVE" in the menu
"Load/Store"
B V Change to the parameter level
Display "0" and "READY"
Select the parameter set in which
the parameters are to be saved
permanently C z Save as parameter set 1:
ð Set "1" "Save PS1"
Save as parameter set 2:
ð Set "2" "Save PS2"
Save as parameter set 3:
ð Set "3" "Save PS3"
Save as parameter set 4:
ð Set "4" "Save PS4"
D T V When "OK" is displayed, the settings are permanently
saved in the selected parameter set.