Lenze EVS93xx - Manual (Page 27)

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Transferring parameters to other standard devices
3
l
27 EDKVS93−02 EN 3.0
Copying parameter sets fom keypad into the standard device
Step Key
sequence Action
1. Connect the keypad to standard
device 2
2. Inhibit controller Terminal X5/28 = LOW
The "IMP" status display is it.
The drive coasts
3. Pull the plugs X5 and X6 All control terminals have the defined "LOW" status.
4. Select C0002 in the "Load/Store"
menu z y Z Y Select code C0002 "PAR LOAD" in the "Load/Store"
menu using the arrow keys.
5. Change to the parameter level V The active parameter set is shown, e. g. display "0" and
"Load Default"
6. Select the correct copy function The settings saved in the standard device are
overwritten.
l Copy all parameter sets available into the
EEPROM of the standard device and save them
permanently. l The parameter set that was active before copying is
overwritten.
l The parameters are not yet active after copying.
Select parameter set and load it in the main
memory.
^ 25
z Set "20" "ext −> EEPROM"
l Copy individual parameter sets into the main
memory of the standard device.
z Copy parameter set 1 into the main memory:
Set
ð "11" "Load ext PS1"
Copy parameter set 2 into the main memory:
Set
ð "12" "Load ext PS2"
Copy parameter set 3 into the main memory:
Set
ð "13" "Load ext PS3"
Copy parameter set 4 into the main memory:
Set
ð "14" "Load ext PS4"
7. Start copying T V The "RDY" status display goes off. As parameter value
"BUSY" is displayed.
If "BUSY" goes off, the parameter sets selected were
copied into the standard device. The "RDY" status
display is lit.
8. Change to the code level
A V Display of the operating level
B V Display C0002 and "PAR LOAD"
9. l If the function "Copy all parameter
sets into the EEPROM"
(C0002 = 20) is selected, they
might have to be loaded in the
main memory manually.
l If the function "Copy individual
parameter sets into the main
memory" (C0002 = 1x) is selected,
they might have to be saved
permanently in the EEPROM
manually.
z y Z Y Select code C0003 "PAR SAVE" in the "Load/Store"
menu using the arrow keys and store the contents of
the main memory permanently.
10. Plug in plugs X5 and X6
11. Enable controller Terminal X5/28 = HIGH
The drive is running with the new settings.