About these instructions – Lenze MCH Series Drives Metasys N2 User Manual
Page 2
This documentation applies to the use of an MCH Series Variable Frequency Drive with Metasys N2 protocol and
should be used in conjunction with the MCH Series Installation and Operation Manual (Document MH01) that
shipped with the drive. These documents should be read in their entirety as they contain important technical data
and describe the installation and operation of the drive.
Metasys® is a registered trademark of Johnson Controls, Inc., http://www.johnsoncontrols.com
© 2003 Lenze AC Tech Corporation
No part of this documentation may be copied or made available to third parties without the explicit written approval
of Lenze AC Tech Corporation. All information given in this documentation has been carefully selected and tested
for compliance with the hardware and software described. Nevertheless, discrepancies cannot be ruled out. Lenze
AC Tech does not accept any responsibility nor liability for damages that may occur. Any necessary corrections will
be implemented in subsequent editions.
About These Instructions