Lenze MCH Series Drives Siemens P1 - Manual (Page 11)

RG-MHSP1F 8
P1 Points
Point
#
Point
Type
Description (P1 Point Name)
ENG/SI
Units
ENG/SI
Slope
ENG/SI
Intercept
ENG/SI On
Text
ENG/SI Off
Text
Default
Value
[41] LDI TB-15 / Relay #3 (TB15.RELAY3) -- 1.00 -- ON OFF 0
[42] LDI Relay #1 (RELAY1) -- 1.00 -- ON OFF 0
[92] LAI Present Fault (FAULT) -- 1.00 0 -- -- 0
[93] LDI Fault Condition (OK.FAULT) -- 1.00 -- FAULT OK 0
[94] LDO Clear Present Fault (CLEAR FAULT) -- 1.00 -- RESET NORMAL 0
99 LAI Error Status Flags (ERROR STATUS) -- 1.00 0 -- -- 0
NOTES:
1. Point numbers that appear in brackets [ ] may be unbundled at the field panel.
2. Point Types: LDI = Logical Digital Input, LDO = Logical Digital Output,
LAI = Logical Analog Input, LAO = Logical Analog Output
4.2 MCH P1 Point Descriptions
Point 1: This point reflects the serial address of the drive. As stated earlier, this point is selectable up
to 99 but should only be set in the range of 1-98 when on the LAN.
Point 2: This point contains the number of the current application. Since this point currently only has
one value, that being 2726, this point is not capable of being commanded.
Point 3: This point is for monitoring the actual speed of the drive in Hz.
Point 4: This point is for monitoring the actual speed of the drive as a percentage of the value set in
Drive Parameter #11 (Maximum Freq). It is rounded to the nearest whole number.
Point 5: This point is for monitoring the actual speed of the drive in RPMs. The value returned by this
point is the actual drive speed in Hz multiplied by the value set in Drive Parameter #32 (Hz
Multiplier) and rounded to the nearest whole number.
Point 7: This point is for monitoring the drive’s load current as a % of rated current.
Point 8: This point is for monitoring the commanded drive speed in Hz.
Point 9: This point is for monitoring the commanded drive speed as a percentage of the value set in
Drive Parameter #11 (Maximum Freq). It is rounded to the nearest whole number.
Point 10: This point is for monitoring the commanded drive speed in RPMs. The value returned by this
point is the commanded drive speed in Hz multiplied by the value set in Drive Parameter #32
(Hz Multiplier) and rounded to the nearest whole number.
Point 11: This point returns the software version (including the current revision) of the drive firmware.
This information can also be obtained from Drive Parameter #63 (Software Version). For
example, drive software version MC09803 will be displayed as 9803.
Point 12: This point is for monitoring the number of hours that the drive has been running since its first
power-up.