Lenze ERBSxxxxxxxx - Manual (Page 52)

6 Electrical installation
Mounting steps
EDKRBS047R DE/EN/FR/ES/IT 8.0
52
l
H1_E_INST−eInstall_EN
Mounting steps
1
0
RB1
T1
T2
RB2
PE
ERBS103
How to connect the brake resistor:
1. Disconnect the basic device from the mains and check that no voltage is applied to
the power terminals.
2. Remove the terminal cover.
3. Connect the brake resistor cable:
– Use a twisted cable for cables up to 0.5 m (connection plan variant 1).
– Use a shielded cable for cables up to 5 m (connection plan variant 2).
– Pass the cable through the cable gland
0.
– Connect the cores to connections RB1, RB2 and PE of the brake resistor observing
the tightening torque. PE connection to EN 61800−5−1.
– Tighten the cable gland 0.
For shielded cables: Securely connect the shield to the cable gland with a surface
as large as possible.
– Connect cores and shield to the basic device observing the documentation for the
basic device.
4. Connect the thermal contact cables:
– Use a twisted cable.
– Pass the cable through the cable gland
1.
– Connect the cores to connections T1 and T2 of the brake resistor observing the
tightening torque.
– Tighten the cable gland 1.
– When integrating the thermal contact into the system monitoring ensure that the
mains supply will be switched off when the brake resistor is overheated.
5. Mount the terminal cover.