3 disconnecting from the pc, Disconnecting from the pc, Commissioning – Lenze EPM-H520 User Manual
Page 76
Commissioning
L
76
EDBEPM-H520 DE/EN/FR 4.0
6.
Load the required project from the HMI Designer to
the keypad. (* “HMI Designer - First steps”)
•
Activate the field “Keypad - Update program”
under ”Downloader”.
•
Activate the field “Keypad - Update firmware”
under ”Downloader”.
– when downloading a project into the keypad
for the first time,
– after an update of the planning tool “HMI
Designer”.
H520_021
“PROGRAMMING MODE” is displayed while downloading data.
7.
After a project download, the program of the system bus adapter must be updated.
!
!
!
!
Note!
!
Example projects for the keypad can be found in the “HMI Designer” planning
tool under
File
-
Open ...
-
Samples .
!
The project remains saved after the supply voltage has been disconnected.
4.2.3
Disconnecting from the PC
1. Switch off the PC.
2. Switch off the supply voltage for the keypad.
3. Remove the EPZ-H110 download cable from the keypad and the PC.
4. Switch on the supply voltage for the keypad.
The keypad is now ready for operation.
Show/Hide Bookmarks