Lenze PLC Designer R3-x - Manual (Page 40)

Working with the sample projects
Sample project with "Table positioning" application - TablePositioning
40
Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2.4 Open the »Engineer« project & go online

How to open the sample project in the »Engineer«:
1. Start »Engineer«.
2. Open the desired project (CAN or EtherCAT) using the FileOpen archive command.
3. Insert the desired motor in the configuration:
• Highlight controller, select the desired motor with the command Insert a component on the
Motors tab
• By clicking Complete, insert the selection in the »Engineer« project.

Detailed information on the general handling of the »Engineer« can be found in the
online help for the »Engineer«, which you can call with [F1].