Lenze PLC Designer R3-x - Manual (Page 49)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014
49
Working with the sample projects
Sample project with "Table positioning" application - TablePositioning
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7.2.6.5 Homing mode
• Button  selects the homing mode.
• The active standard setting in the controller is homing mode 12 (travel to negative limit
switch / digital input 3)
• Button  starts the homing.
• Button  stops homing.
• Button sets the home position.
• Button  resets the home position.
• Set reference / Pos Act = 0 unit
• Dialog box  shows the homing status.
 Select mode  Stop button Status of the service mode
Start button  Activate clockwise
rotation
 Actual speed