Lenze 8400 motec - Manual (Page 363)

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05 363
11 Parameter reference
11.2 Parameter list | C00169
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00169
C00170
C00171
C00173
C00174
Parameter | Name:
C00169 | Time of error
Data type: UNSIGNED_32
Index: 24406 d = 5F56 h
Display range (min. value | unit | max. value)
0 4294967295
Subcodes Info
C00169/1 Display of the time of error for the last 8 occurred errors
C00169/...
C00169/8
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00170 | Error counter
Data type: UNSIGNED_8
Index: 24405 d = 5F55 h
Display range (min. value | unit | max. value)
0 255
Subcodes Info
C00170/1 Display of the error counter for the last 8 occurred errors
C00170/...
C00170/8
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00171 | Logbook access index
Data type: UNSIGNED_8
Index: 24404 d = 5F54 h
This code is for device-internal use only and must not be written to by the user!
Parameter | Name:
C00173 | Mains voltage
Data type: UNSIGNED_8
Index: 24402 d = 5F52 h
Selection of the mains voltage for operating the device.
Selection list
(Lenze setting printed in bold)
0 3ph 400V
1 3ph 440V
2 3ph 480V
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00174 | Reduc. brake chopper threshold
Data type: UNSIGNED_8
Index: 24401 d = 5F51 h
Note:
In case of the 8400 motec, this parameter has no influence. The brake chopper is triggered via a hardware circuit.
The threshold cannot be parameterised.
Setting range
(min. value | unit | max. value) Lenze setting
0 V 150 0 V
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1