6 enabling controller and selecting speed, Enabling controller and selecting speed, 3commissioning – Lenze 8400 motec User Manual

Page 41

Advertising
background image

Lenze · 8400 motec · Reference manual · DMS 4.1 EN · 08/2013 · TD05

41

3

Commissioning

3.5

Commissioning of the "Actuating drive speed" technology application

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

3.5.5

Saving parameter settings safe against mains failure

The parameter set must be saved to the device safe against mains failure to prevent parameter

settings becoming lost due to mains switching.

•

Saving parameter set

3.5.6

Enabling controller and selecting speed

If the controller is in the "

SwitchedOn

" status:

1. Enable controller: Set terminal RFR to HIGH level.
2. Select speed:

• In the "Terminals 0" by selecting a voltage at the analog input or by selecting a fixed setpoint

via the digital inputs DI1/DI2.

Stop!

Before stipulating a speed setpoint, check whether the brake in the form of a holding

brake on the motor shaft has been released!

Note!

If the controller is enabled and the "Inhibit at power-on" auto-start option is activated in

C00142

(Lenze setting) when the mains is connected, the controller remains in the

"

ReadyToSwitchOn

" state.

In order to change to the "

SwitchedOn

" status, the controller enable must first be

cancelled: Set terminal RFR to LOW level.

DI1

DI2

Speed selection

LOW

LOW

The main speed setpoint is selected via the analog input 1

• Scaling: 10 V ≡ 100 % reference speed (

C00011

)

HIGH

LOW

The fixed setpoint 1 (

C00039/1

) is used as main speed setpoint.

• Lenze setting: 40 % of the reference speed (

C00011

)

LOW

HIGH

The fixed setpoint 2 (

C00039/2

) is used as main speed setpoint.

• Lenze setting: 60 % of the reference speed (

C00011

)

HIGH

HIGH

The fixed setpoint 3 (

C00039/3

) is used as main speed setpoint.

• Lenze setting: 80 % of the reference speed (

C00011

)

Note!

Observe the actual speed value (display in

C00051

) and the

LED status display

at the

controller.

Advertising