Loadstar Sensors DQ-4000 - Manual (Page 21)

DQ-4000 DQ-4000 User's Guide
Page: 21 / 21
P/N : 033-02061 Rev. 1
4.15 CCA, CCB, CCC, CCD, TCA, TCB, TCC & TCD Commands
Function: Set (or report) cubic fit parameters for selected channel
Summary: Use these commands to set or list the various parameters for a cubic fit.
Typically, these values will be provided to you by Loadstar based on a factory
calibration. Also, typically the parameters for the compression side and the
tension side are the same (e.g., CQA and TQA will have identical values).
However, in some applications, these parameters may be different.
Example CCA 2.09876E-14 (set the value of CQA to be 2.09876E-14
CCD (report the value of CCD)
4.16 SST (Sensor Status) Command
Function: Returns the command summary
Summary: Use this command to display the whether the sensor is connected. A value of [0]
means the sensor is disconnected.
Example SST (displays which sensor is connected)
4.17 SETTINGS Command
Function: Returns all current setting values
Summary: Use this command to display the settings of the sensor parameters.
Example SETTINGS (display currently selected channel)