MBT Lighting LEDFLOORPACK - Manual

1
LED FLOOR PACK
USER MANUAL
INTRODUCTION
Thank you for having chosen a LED FLOOR PACK. If you follow the instructions given in this manual,
we are sure that you will enjoy this device for a long period of time.
SAFETY INSTRUCTIONS
CAUTION!
Be careful with your operations. With a dangerous voltage you can suffer a dangerous electric shock when touching
the wires!
OPERATION
After you connected the spot to the mains, the LED FLOOR PACK starts running.
OPERATION VIA FOOT SWITCH
Connect the foot switch with the device via the 5-pin connection cable with plug.
The foot switch can be operated in sound controlled (*SND) or in DMX-controlled (*512) mode.
The default mode is AUTO; every time you start the device, the mode is what you set last time.
Pedal functions:
Pedal 1: Preset
- 1 x press = White
- 2 x press = Red
- 3 x press = Green
- 4 x press = Blue
- 5 x press = Yellow
- 6 x press = Magenta
- 7 x press = Cyan
- 8 x press = Color change every second in a continuous loop as described above.
- 9 x press = Color fade every 3 seconds in a continuous loop as described above.
Pedal 2: Sound controlled
Pedal 3: Freeze
Pedal 4: Black Out
Master/Slave-Operation
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices.
Set the Master device to SOUND/AUTO mode and set each Slave device to the same DMX address (A001).
The device has two operating modes. It can be operated in sound controlled or in DMX-controlled mode.
You can choose the desired mode via the buttons MENU, UP and DOWN:
When the display shows A*** , you can choose the desired DMX addresses via the UP or DOWN buttons.
When the display shows *512, the device is in DMX mode. To switch to sound controlled mode, press the
DOWN button.
When the display shows *SND, the device is in sound controlled mode. To switch to DMX mode, press the
DOWN button.
When the display shows *AUTO, the device is in auto mode. The program runs at a fixed speed, which can
be set under S***.
When the display shows S***, you can choose the desired speed of the internal programs. Default is 51; for
increasing speed press the DOWN button, for decreasing speed press the UP button.
DMX-CONTROLLED OPERATION