MBT Lighting LEDPARPACK - Manual (Page 2)

OPERATING INSTRUCTION
Mode setting
0=OFF 1=ON X=0FF or ON
DIPSWITCH CHART FUNCTION
1 2 3 4 5 6 7 8 9 10 _
X X X X X X X X X 0 AUTO MODE
X X X X X X X X X 0 MASTER MODE
1 0 0 0 0 0 0 0 0 1 SLAVE MODE
SET DMX ADDRESS 1 DMX MODE
1) AUTO Mode
Set the dip switch #10 to OFF, LED PAR Light enters AUTO Mode, running the built-in
programs automatically; the other dip switches 1-9 control the speed of the programs.
2) MASTER/SLAVE Mode
Master: set the dipswitch #10 of one LED PAR Light to OFF; the other dip switches 1-9
control the speed of the programs.
Slave: set all the dip switch #1 & #10 to ON, #2-9 dip switches to OFF
3) LEDC control
One LEDC can control only 4 LED PAR Lights at most. To use LEDC with LEDPAR96,
connect the system using DMX cable, then set address for the LEDPAR96. Each LED
PAR CAN takes up 5 DMX channels. So, set start channel for the first LED PAR Light to
1st channel, second LED PAR Light to 6th channel, third LED PAR Light to 11th channel,
fourth LED PAR Light to 16th.
EASY LEDPAR DMX SWITCH GUIDE:
Light# = DMX Channel/Dipswitch Setting
1 = 1/switch 1 ON
2 = 6/switches 2&3 ON
3 = 11/switches 1,2&4 ON
4 = 16/seich 5 ON
4) DMX Mode
Set the dipswitch #10 to ON, LED PAR Light enters DMX Mode; the other 1-9 dip
switches are for addressing.