MK Diamond MK-101 - Manual (Page 25)

25
MK-101 OPeRaTiON
NOTe: To cut angles other than 45º angles or Miters, a 90º Protractor (MK Diamond Part No.
134569-MK) should be used.
(C)
Position the tile against the 90º
Protractor and the Ruler/Stop
(D)
Turn the motor ON. Verify
proper cooling flow on both
sides of the blade
(A)
Place the 90º Protractor on
the Ruler/Stop
(B)
Set the desired angle and
tighten the thumbscrew and
tighten retaining thumbscrews
(E)
Perform the cut. Turn the motor
OFF when work is complete
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for
which it was designed. CAUTION
OFF-aNGle CUTTiNG