MK Diamond MK-1590 - Manual (Page 10)

10
TRAIL RACK SAW SAFETY
D & F
(behind)
A
The MK Diamond Track Rail Saw is equipped with a number of safety decals. These decals are pro-
vided for operator safety and maintenance information. The illustration below also shows the location
of these decals. Should any of these operation or safety decals become unreadable, replacements
can be obtained by calling (800) 262-1575.
OPERATION & SAFETY DECALS
WARNING
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
!
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
DO NOT operate
this equipment
before reading
the owners’
manual!
WARNING !
CAUTION
DO NOT
operate without
guards in place.
!
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’ 100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length No. 12 Wire
No. 10 Wire
No. 8 Wire
115v 230v
NOTICE !
This saw is to be used
with a Ground Fault
Circuit Interrupter.
! CAUTION
Decal A Decal B
Decal C
Decal D
Decal E
Decal F
Figure 1. MK Diamond Track Rail Saw Safety Decal Sheet, Part No. 166011
C
B
E