MK Diamond MK-1590 - Manual (Page 18)

18
TRACK RAIL SAW OPERATION
Plunge Cutting for a Miter Cut
1. Loosen the Round Knob (A) and adjust the blade to the desired angle (0-45 degrees). Tighten
the Round Knob. Recheck the set angle along the entire rail system.
2. Loosen the Tri-Knob (B). Raise the blade to the highest position and move the Saw Assembly
to the beginning of the cut.
3. Adjust the Valve (C) for the desired amount of water flow.
4. Depress motor switch and lower the blade slowly into the material.
5. Tighten the Tri-Knob (B) once the blade cuts through the material. Follow the direction of the cut.
B
A
C