MK Diamond EC7600 - Manual (Page 15)

15
NOTE:
For units equipped with a water kit,
loosen the (2) water nozzles and
disconnect the main water line from
the double nozzle.
1. Remove the cutting wheel (See
pages 10 and 11). Using a Phillips
screwdriver, loosen the tension
screw until the tension indicator is
all the way to the front of the scale.
See Figure 15.
Figure 15
Figure 18
4. Remove the blade mount from the
mounting surface and rotate the
blade mount 180
0 , then remount to
the right hand side of mounting
surface. See Figure 18.
Reversing cutting head for flush cutting operations
Tension Screw
Tension
Indicator
Belt Guard
WARNING!
Before performing any work on the cut-off saw, make sure the engine is
stopped and the ignition switch is OFF.
Remove Cutting Wheel
Loosen
Two Bolts
2. Back off tension screw another 4-5
turns so that adequate clearance is
achieved where the tension screw
contacts the mount when the mount
is turned over. See Figure 16.
Figure 16
Mount Tension Screw
Figure 17
3. Using a 6mm hex wrench, remove
the two belt guard bolts and slide
the belt guard forward to remove.
See Figure 17.
6mm Socket-
Head Bolts