MK Diamond EC7600 - Manual (Page 24)

24
The engine does not start.
PROBLEM
Remove the spark plug (pg 13).
Is the spark
plug wet?
Cutting performance is poor.
PROBLEM
Make sure the choke is
pushed fully in.
Make sure the air
cleaner is clean (pg 17).
Make sure the drive belt is
properly tightened (pg 19).
Make sure the carburetor is
is properly adjusted (pg 18).
Make sure the cut-off wheel is
appropriate for your work.
Make sure the diamond
wheel is sharp.
Dry the
spark plug.
Inspect the
spark plug
(pg 19).
Pull the recoil
starter several
times to
remove fuel
from the
cylinder.
If the above inspections and maintenance procedures do not
correct the problem, contact your Shindaiwa dealer for assistance.
Make sure the fuel tank contains
with clean, fresh fuel (pg 11).
Is the spark
plug dry?
Replace the
fuel filter
(pg 22).
Troubleshooting