Mk-5005s operation – MK Diamond MK-5005S User Manual
Page 23
Advertising
23
MK-5005S
oPERaTIoN
angle cuts
Angle Cuts may be performed using the Step Cut, Chop Cut, Cutting Head Positioned Down methods
or with the masonry piece positioned vertically. The following example utilizes the Step Cut method.
(A)
Reposition adjustable Cutting
Guide. Align 45° Slots to Ruler/
Stop
(C)
Open the Cooling Flow Control
Valve and adjust flow. Verify
proper cooling flow on
both sides of the blade
(B)
Position the masonry piece.
Adjust the height of the Cutting
Head as necessary, start motor
(D)
Lower Cutting Head 1/4" -1/2"
during “Push” Stroke
(E)
Lower Cutting Head 1/4" -1/2" dur-
ing “Pull” Stroke. Repeat Steps D
and E until cut is complete. Turn the
saw off when work is complete
Advertising