MK Diamond MK-6000 Series - Manual (Page 23)

23
MK-6000 SaW oPeration
WarninG
Observe the rotation arrow on blade and Do not exceed maximum RPM stamped on the blade. To
set proper RPM, consult the Blade Guards and Blade Sizes.
notiCe
To meet ANSI safety standards, larger diameter blade flanges are required for large diameter blades.
Information is available upon request or for complete safety information refer to ANSI Safety Code B7.1
notiCe
We recommend the use of MK Diamond Products diamond blades with these saws.
BLaDe MountinG inStruCtionS ContinueD
FLanGe DiaMeter BLaDe DiaMeter
4" 20"
5" 26" up to 30"
6" 36"
7" 42"
PoSitioninG tHe SaW
Position the handles to suit the operator and conditions. The saw may be pivoted like a wheelbarrow
by lifting the rear wheels and rotating the saw into position. If moving the saw more than a few feet
or up and down ramps, start the engine and drive.