MK Diamond MK-6000 Series - Manual (Page 27)

27
This saw is driven by a hydrostatic transmission. To engage the transmission, PuLL the Neutral En-
gagement handle up and turn to either direction to lock.
To disengage the transmission, twist the Neutral Engagement handle to unlock, and PuSH down.
notiCe
Do not engage the unit unless FNR handle is on neutraL.
ENGAGING THE DRIVE UNIT
Water HooK uP
Prior to starting the engine, you should hook up the water hose to the Water Inlet and visually inspect
it to make sure that water is flowing to the blade. Hook up the hose to the unit and turn on the water
source. Open the water valve.
Next, lift the front of the blade guard and visually inspect to make sure water is flowing out of each of
the tubes. If any of the holes are blocked, flush impurities from the tube.
notiCe
Water flow volume can be metered by opening the water valve partially.
engage transmission
Neutral
Engagement
Handle
FNR Handle
Water
Valve
Water Hook up
Water Inlet
MK-6000 SaW oPeration