0 applying offsets to the input signal—optional, Applying offsets to the input signal—optional – MTS Multipurpose Express User Manual

Page 22

Advertising
background image

Figure 3: Station Manager Manual Controls

a) Click the Manual Command button to open the Manual Command window.
b) Select the Channel to control.
c) Select the desired Control Mode.
d) Select the Enable Manual Command check box.

3. Install the specimen.

a) Use the Manual Cmd slider bar to position the actuator, or type the desired value and press Enter on

the keyboard.

b) Install the specimen as required by your test.

4. Click to clear the Enable Manual Command check box.

5. Clear the Exclusive Control check box.

4.2.4.0 Applying Offsets to the Input Signal—Optional

Depending on the test, you may be required to zero the load and apply offsets and perform other setup
procedures.

22 MTS TestSuite

4.0 Operator Procedures

Advertising