MTS SWIFT 50 GLP Sensor - Manual (Page 41)

Road and Track Vehicles
SWIFT 50 GLP Sensors Installation Installing the Transducer 41
D. Secure the top plate to the standoffs using the four M12 bolts and
washers.
Lubricate the threads with Molykote g-n paste and torque to 93 N•m
(69 lbf•ft).
E. Install the slip-ring bracket with the slip ring, conduit bracket, and
restraint tube.
Slide the restraint tube through the hole in the anti-rotate bracket
(installed earlier) as far as necessary to align the slip-ring bracket to the
connectors on the top plate.
The slip-ring bracket fits over the 9-pin connectors on the top plate at
the locations labeled Board A and Board B. The slip-ring bracket is
similarly labeled to prevent connecting it the wrong way.
Standoffs (4)
Top Plate Slip-Ring
Bracket
M12 Threaded
Studs (4)
Extension
Brackets (4)
S50-40
M12 Bolts (4)
and Washers
Anti-rotate
Hinge
Assembly
Tube
Cable
Cable
Conduit
Bracket
Slip
Ring
Hinge
M8 Bolts (4)