MTS SWIFT 50 GLP Sensor - Manual (Page 54)

SWIFT 50 GLP Sensors Installation 54
Road and Track Vehicles
Installing the Transducer
The indicators will flash at a rapid rate for several seconds, then turn
off, indicating the procedure is complete.
C. If the both indicators continue to slowly flash after 2 minutes, or if the
red Fail indicator flashes, there is an error in the zero process. Run
TISTATUS to find out more information. Repeat Steps A and B. If you
continue to have an error, consult the chapter
, “Troubleshooting,” in the
SWIFT 50 GLP Sensor Product Information manual (MTS part
number 100-162-722).
D. After completing the Bridge and Angle Zero procedure, rotate the
wheel one full revolution clockwise.
This allows the electronics to locate the index pulse for the encoder.
E. Perform , “Verifying the Quality of the Zero Procedure,” on page 55.
F. Look at your data acquisition system to verify that the SWIFT sensor is
gathering data.