MTS Criterion Series 60 - Manual (Page 40)

MTS Criterion™ Series 60 40
Appendix
Foundation Requirements
• Cast the foundation according to the above drawings and dimensions.
• The compression stress of the concrete used for the foundation should be no
less than 35 Mpa (5000 psi).
• Refer to the previous table for anchor bolts. The tensile stress of the bolts
should be no less than 450 MPa (64286 psi). Tighten the bolts with cushion
rings, spring cushions, and nuts on the frame base. After the tightening, the
bolts should extend 5-10 mm (0.2-0.4 in) above the nuts.
• While recasting the reserved holes, keep the anchor bolts at the centers of
the holes.
• Recast the reserved holes to the same plane of the floor. Cure the foundation
until it is qualified for use.
• The degree of the foundation level should be no more than 0.2/1000.
Note The above foundation drawings are for reference only; you can make
alternations according to your actual needs.
Foundation Board Measurement
64.305EL 64.605/64.605EL 64.106/64.106EL
Ⅰ
(L×W×T)
840Ч828Ч50 mm
(33Ч32.6Ч2 in)
996Ч829Ч50 mm
(39.2Ч32.6Ч2 in)
1126Ч825Ч50 mm
(44.3Ч32.4Ч2 in)
Ⅱ
,
Ⅳ
(L×W×T)
2305Ч840Ч50
mm
(90.7Ч33Ч2 in)
2330Ч840Ч50 mm
(91.7Ч33Ч2 in)
2440Ч840Ч50 mm
(96.2Ч33Ч2 in)
Ⅲ
(L×W×T)
840Ч852Ч50 mm
(33Ч33.5Ч2 in)
996Ч855Ч50 mm
(39.2Ч33.6Ч2 in)
1126Ч858Ч50 mm
(44.3Ч33.7Ч2 in)
a
(Gap)
115 mm
(4.5 in)
163 mm
(6.4 in)
168 mm
(6.6 in)
b
(Gap)
812 mm
(32.0 in)
815 mm
(32.0 in)
818 mm
(32.0 in)
Ⅴ
[Rect. tube of 5
mm (0.2 in)
thickness]
140Ч80Ч2580
mm
(5.5Ч3.3Ч101.7
in)
140Ч80Ч2736 mm
(5.5Ч3.3Ч107.8 in)
140Ч80Ч2866 mm
(5.5Ч3.3Ч113.0 in)