Northern Connectors Harting DIN 41 612 Connectors - Manual (Page 206)

30
.
10
02 99 000 0007
09 99 000 0278
To
ol
in
g
Repair tooling
Identification for use with Part No. Drawing Dimensions in mm
rear
I/O shroud
har-bus ® 64
rear
I/O shroud
Type C, 2C
R, 2R
Removal tool
for shroud
Replacement of complete har-bus ® 64 press-in connectors
Steps in detail
1. Lever up the moulding by using a removal tool
a) The removal tool with Part No. 02 99 000 0003 is suitable for repairing small quantites. It can only be used
if the adjacent components on the pcb are at least 2 mm apart from the moulding of the connector.
b) The removal tool with Part No. 02 99 000 0006 is suitable for repairing large quantities. Due to its
design it can also be used if components on the pcb are in close proximity to the moulding of the
connector.
2. Lever up the rear I/O shroud with the removal tool 02 99 000 0007. This step is only required with 17 mm
termination length.
3. Pull out the female contacts with the press-out tool
a) for 17 mm termination length use Part No. 02 99 000 0004 and
b) for 5 mm termination length use Part No. 02 99 000 0008.
During this process the press-out tool replaces the top tool and the pcb is supported by the support block
(Part No. 02 99 000 0005) from the bottom.