System description with switches – Northern Connectors Harting DIN 41 612 Connectors User Manual
Page 98
02
.
06
ha
r-
bu
s 6
4
As a typical multiprocessor bus,
VME has to distribute processor
information continuously accord-
ing to the right priorities.
This is done through the well
known daisy-chain lines.
The VME protocol requests 5
daisy-chains on position 1 of
every backplane.
These lines are defined to go
through every daughter card.
Therefore, in case of unloaded
card slots the signal have to be
bridged across the connector.
Bridging variants:
1. The empty card slots may be assembled with
dummy cards, that bridge the
daisy-chain
lines.
2.
Bridging can be achieved by inserting
5 jumpers on the back plane manually.
3. Bridging by using IC's with internal integration
OR the function may accept automatic daisy-
chaining.
4. The new 5-row
connector with switches
allows an automatic switching. In the case of an
unmated daughter card the connector bridges
the signals at positions a21-22, b4-5, b6-7,
b8-9 and b10-11. The switch elements open
automatically when the daughter card is mated,
so that the daughter card accepts the ongoing
signal daisy-chain.
System description
with switches
daughtercard
male connector
female connector
OR-gates
IN
OUT