Pololu Orangutan USB - Manual (Page 12)

navigate to your project’s folder, you should find it as “default\<project name>.hex”. Click the Program
button (make sure you click the one in the Flash section, not one in the “EEPROM” or “ELF Production File
Format” sections!).
AVR Studio’s Program ISP tab
You should see both the red and the green programming status LEDs flicker on your Orangutan USB
programmer as it programs and you should see the following text appear in the text box at the bottom of the
Program window:
Reading FLASH input file.. OK
Setting mode and device parameters.. OK!
Entering programming mode.. OK!
Erasing device.. OK!
Programming FLASH .. OK!
Reading FLASH .. OK!
FLASH contents is equal to file.. OK
Leaving programming mode.. OK!
Pololu Orangutan USB Programmer User's Guide © 2001–2011 Pololu Corporation
5. Getting Started Using Windows Page 12 of 32