Pololu Orangutan USB - Manual (Page 28)

1. Run Tera Term Pro v2.3
You will be greeted by a “TeraTerm: New connection” dialog box. Click cancel, then go to the “Setup” menu and
select “Serial port…”.
Configure the settings as shown below, substituting your own COM port. The baud rate should be 115200 with
8-bit data, no parity, one stop bit, and no flow control. You do not need any transmit delays. The only settings you
should have to change from their default values are the port and the baud rate. Do not click OK yet.
Pololu Orangutan USB Programmer User's Guide © 2001–2011 Pololu Corporation
8. Updating Your Programmer's Firmware Page 28 of 32