MacDon M100 SP Operators Manual User Manual
Page 68
OPERATOR’S STATION
169304
66
Rev. C
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight box attached to
windrower, ensure that float engagement
pin is installed in storage location (K), and
not installed at hole location (L).
i.
Remove pins (M) securing lift linkages to weight
box, and retain pins for attaching header to
windrower.
j.
Lower weight box onto blocks and back away.
k. Attach header to windrower. Refer to Section
6.5.1 Header Attachment.
l. Convert header into field position. See Header
Operator’s Manual for procedure.
m. Start engine and lower header to ground.
Continue to retract lift cylinders so that member
(N) lifts off link (O).
n. Remove temporary lift pins (P) from lift arms and
install pins into storage holes in weight box.
o. Before operating the machine, double check that
all pins are secure, and that all safety equipment
is installed and fully functional.
p. Proceed with operation of header.
M
L
K
P
N
O