MacDon M100 SP Operators Manual - Manual (Page 71)

HEADER OPERATION
169304
69
Rev. C
6.4 HEADER OPERATION
The M100 Windrower is designed to use the
MacDon A Series auger header with hay
conditioner, and D Series Rigid Draper headers
with or without hay conditioners. This section
describes the attachment and detachment
procedures and operating instructions for these
header types.
6.4.1 Header Lift Cylinder Stops
Cylinder stops are located on both header lift
cylinders on the windrower. To avoid bodily
injury or death from fall of raised header, always
engage cylinder stops before going under
header for any reason. Engage cylinder stops
as follows:
a. Press HEADER UP swich to raise header to
maximum height.
NOTE
If one end of the header does not raise
fully, the lift cylinders require re-phasing.
Proceed as follows:
1. Hold the up switch until both cylinders stop
moving.
2. Press HEADER DOWN switch to lower the
header all the way down, and continue to
hold the switch for 3-4 seconds.
3. Raise the header again to full height.
b. Pull lever (A) and rotate toward header to
release and lower cylinder stop (B) onto
cylinder. Repeat for both lift cylinders.
c. To store, turn lever (A) away from header to
raise stop until lever locks into vertical position.
B
A
HEADER UP
HEADER DOWN