MacDon 9352i SP - Manual (Page 113)

Form # 147141 Issue 02/06 Web Rev_01 111
MAINTENANCE/SERVICE
Maintenance Schedule
The following maintenance schedule is a listing of periodic maintenance procedures, organized by service
intervals. For detailed instruction, see the specific heading in Maintenance/Service section. Use "Fuels, Fluids
and Lubricants as specified under that heading.
SERVICE INTERVALS
The recommended service intervals are in hours of operation. Use the hour meter in the cab to indicate when
the next service interval has been reached.
IMPORTANT: Recommended intervals are for average conditions. Service windrower more often if operated
under adverse conditions (severe dust, extra heavy loads, etc.). Regular maintenance is the best insurance
against early wear and untimely breakdowns. Following this schedule will increase machine life.
Where a service interval is given in more than one time frame, eg. "100 Hours or Annually", service the
windrower at whichever interval is reached first.
CAUTION: Carefully follow safety messages given under "Service Procedures".
AT FIRST USE:
See "Break-In Period" in Operation section.
10 HOURS OR DAILY
1. Grease transmission driveline slip-joint.
2. Check tire inflation.
3. Check engine oil level.
4. Check engine coolant level at reserve tank.
5. Clean radiator, hydraulic oil cooler, and A/C
condenser.
6. Clean cab fresh air intake filter.
7. Check hydraulic oil level.
8. Check air cleaner restriction gauge. Clean
element when indicated.
9. Fill fuel tank.
10. Check fuel sediment bowl, clean if necessary.
11. Drain fuel filter water trap - diesel engine.
50 HOURS
1. Grease driveline.
2. Grease caster pivots
3. Grease header drive pulley.
4. Grease header clutch pivot.
5. Grease transmission driveline u-joints.
6. Grease walking beam center pivot.
7. Grease top lift link rear pivot.
8. Grease forked caster spindle bearings.
(16.5 tire only)