MacDon 9352i SP - Manual (Page 51)

Form # 147141 Issue 02/06 Web Rev_01 49
OPERATION
Header Levelling
A 1/4 inch (6 mm) shim (A) is located on both
sides of windrower lift linkage. If header is not
level, adjust as follows:
1. Lower header onto a block so back of linkage
lifts.
2. Remove hardware (B) on the high side of the
header and remove shim (A). Replace hard-
ware (B).
3.
Check header level. If more levelling is
required, install the removed shim on opposite
side of linkage, adding it to the existing shim.
4. If header is still not level, additional shims are
available from your dealer.
A
B
HEADER LEVELLING