MacDon 9352i SP - Manual (Page 75)

Form # 147141 Issue 02/06 Web Rev_01 73
MAINTENANCE/SERVICE
Diesel Engine: Fuel System
FUEL FILTERS
Change fuel filters every 500 hours of operation.
To change:
1. Close valve (A) under fuel tank to shut off fuel.
2. Replace in-line fuel filter (B) with a new filter.
(Located in fuel supply line between tank and
engine.)
3. At the spin-on filter, clean the filter head, filter
(C) and the engine area next to the filter.
4. Remove the filter (C) using a filter wrench.
5. IMPORTANT: Fill the new filter with clean fuel
and apply a thin film of clean oil to the filter
gasket.
6. Install the new filter. Turn the filter onto the
mount until the gasket contacts the filter head.
Tighten the filter an additional 2/3 turn by hand
or with a filter wrench.
IMPORTANT: Do not overtighten filter. Over-
tightening can damage the gasket and the filter.
7. Open valve (A) under tank.
FEED PUMP STRAINERS
Clean the fuel feed pump strainers every 500
hours of operation. One strainer is incorporated
with the feed pump inlet side joint bolt (D), and the
other is with the water/sediment separator inlet
joint bolt at (E).
Clean the strainer with compressed air and rinse in
fuel oil.
C
FUEL FILTER
D
FEED PUMP STRAINER LOCATION
A
FUEL SHUT-OFF VALVE
E
FEED PUMP STRAINER LOCATION
IN-LINE FUEL FILTER
B