MacDon 9352i SP - Manual (Page 70)

Form # 147141 Issue 02/06 Web Rev_01 68
MAINTENANCE/SERVICE
Diesel Engine
ENGINE SPEED:
Engine maximum and low idle speeds are factory set to specifications listed on page 13.
IMPORTANT: Do not remove any seals from injector pump; removal of seals will void engine warranty. If
specified speeds can not be maintained, see your Windrower dealer.
THROTTLE ROD ADJUSTMENT
Throttle lever in cab should move fuel pump lever
the full range between slow speed stop and full
RPM stop without contacting the console at either
end. To adjust, reposition cable anchor in slots (C).
NOTE: In addition to in-cab tachometer, hand held
tach can be attached at bevel gear box output
shaft. For access to end of shaft, remove cover (D)
on right side of tractor frame.
VALVE TAPPET CLEARANCE
Every 1000 hours of operation, have diesel engine
valve tappet clearance checked and adjusted by
your Windrower dealer.
GENERAL ENGINE INSPECTION
Every 2000 hours of operation, see your
Windrower dealer for required general service or
tune-up.
For diesel engine, have fuel injection pump and
nozzles inspected at this time.
C
THROTTLE ROD ADJUSTMENT
D
ACCESS TO GEARBOX SHAFT
FOR TACHOMETER